Turn Power to INT (Internal), remember to turn off when not using in order to save batteries.
Press "batt test". If VU meter reads -9 the batteries will soon need charging.
Input Panel:
Select a Channel
Is it a mic? if Yes select mic, if No select Line
Does the Mic need power? If Yes choose 48P, If No choose den (Dynamic)
Set VU LED to LO, High will drain batteries quicker.
Turn Limiter ON, will help stop distorting when signal becomes too loud.
Make sure headphones knob is turned up and headphones plugged in.
Output Panel:
The output of the mixer must match the input of the recorder.
Marantz PMD660 - select MIC if recording through a XLR cable
Camera is best to set the mixer to live and the cameras input to line.
Setting Levels:
on the front panel you can tune the sound with the knob. sound should be between -9 and -3 when the knob is between 10 and 3 o'clock.
If seems too loud switch the 0 20 100 switch on to input panel onto 10. This will reduce the the sound by 10 decibels.
The 140 20 100 switch filters out low frequency
set to 100 for voice recordings
set to 0 for full recordings
Other Swithes:
Rtn/Mix switch changes between being able to records and listen back to pre-recorded clips
LT RT Stereo allows the headphones to monitor both channels (stereo) or just the left or right channel
L Pan R if in centre this will send the signal to both left and right outputs, if recording 2 voices then pan on elect and pan one right to keep separate.
0 comments:
Post a Comment